Vinten-radamec Quattro SE PDA Manuel d'utilisateur télécharger pdf (Page 28)

26 Quattro PDA Operators Guide

4. When both axes are found, the main window is displayed and a message indicating that homing is

complete appears (Figure 3).

Displaying coordinate information for the

camera, pedestal and head axes

The main message window (13) on the main window can display coordinate information relating to

all axes of the camera, head and pedestal when in navigation mode (5). To display coordinate

information, select AXIS DISPLAY (9) on the main window—the information will continually

update in the main message window (13). Selecting AXIS DISPLAY (9) again will stop the

coordinate information updating, holding the latest coordinate information in the message window

(13). Reselecting AXIS DISPLAY (9) will restart coordinate information updates in the main

message window (13).

Communicating navigational and positional

data to the VR system

Selecting RUN NAV (5) starts the navigation process and sends positional data to the studio VR

system. The RUN NAV (5) command can only be selected when all three wheel angle encoders have

been zeroed (see How to zero the Quattro SE pedestal steering (wheels) on page 20).

When nav mode is running, the RUN NAV button (5) will change to a STOP NAV button (5) and the

nav mode indicator (6) is selected (displays a ‘tick’). Selecting the STOP NAV button (5) will cause

the Quattro SE pedestal to stop updating its position and will cease VR data packet transmission.

NOTE: The main message window (13) can be configured to show axis

information either as positional measurements (default), encoder

counts (diagnostic) or wheel angles (diagnostic). For more detail refer

to ‘Changing the Display options’ on page 30.

NOTE: 1. Selecting OK (27) to exit the setup display, and accept setup

changes, will turn off NAV MODE (6). Select RUN NAV (5) to re-

establish communication to the studio VR system.

2. Ensure that the virtual datum in the VR system corresponds with

the origin of the studio floor target for the Quattro-SE pedestal (Figure

6) (Figure 7).

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Vinten-radamec Quattro SE PDA Manuel d'utilisateur Page 28