Vinten-radamec Quattro SE PDA Manuel d'utilisateur télécharger pdf (Page 23)

Publication Part No. V4015-4980 Issue 2 21

Homing the Quattro SE system

When the Quattro SE system is initially powered up it will set X, Y (floor) travel and pedestal

orientation to zero, therefore the pedestal must be ‘homed’ relative to a floor target. Periodically the

error in X, Y (floor) travel and pedestal orientation will increase to a level where it is necessary to

‘rehome’ the pedestal relative to a floor target.

There are currently two versions of the Quattro-SE pedestal, each using a different optical sensor

arrangement and floor target. The MK I pedestal uses a three-line floor target (Figure 6) and the MK

II pedestal uses a two-line reflective tape target (Figure 7).

• From the Quattro PDA main window, select HOMING (10). The Homing window appears

(Figure 5).

Homing a MK I pedestal

To home a MK I pedestal to the studio target datum (X and Y axis):

1. Select 3 LINE TARGET (18) from the homing window (Figure 5). You can return to the main

window without affecting homing settings by selecting cancel (21).

2. Position the pedestal over the floor target as shown in (Figure 6), ensuring that the pedestal

orientation is also approximately correct.

NOTE: Before you start the homing process, check which version of pedestal

you are using by looking at the floor target installed.

Figure 5 Homing window

(18)

(19)

(20)

(21)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Pas de commentaire

Vinten-radamec Quattro SE PDA Manuel d'utilisateur Page 23