Vinten-radamec Quattro SE PDA Manuel d'utilisateur télécharger pdf (Page 32)

30 Quattro PDA Operators Guide

2. If required, select the folder containing the setup files using the drop down menu (40) and ensure

that *.dat file types are displayed (38).

3. Select the required setup file (39) from the list to open it, or CANCEL to exit without opening any

files.

Changing the Display options

The main message window (13) can display either positional measurement data, encoder counts (for

diagnostic use) or wheel angles (for diagnostic use).

To alter the units shown in the main message window (13):

1. Select SETUP (2) from the main window (Figure 3).

2. Select either the POSITION, ENCODERS or WHEEL ANGLES options (28).

3. Select OK (27) to save your settings—selecting CANCEL (26) will exit without saving any changes

to the setup).

Setting the offset trim

The offset trim function allows the operator to adjust the physical camera position with respect to the

virtual camera position, to remove error without needing to re-home the pedestal on the floor target.

To adjust the camera position to match the virtual camera position:

1. Select OFFSET TRIM (4) from the main window (Figure 3).

2. Select START OFFSET TRIM (41) from the Offset trim window (Figure 15).

NOTE: The default location for all setup files (.dat) is the My

Documents\Quattro folder.

NOTE: Selecting OK (27) to exit the Setup window, and accept the setup

changes, will turn off NAV MODE (6). Select RUN NAV (5) to re-

establish communication to the studio VR system.

NOTE: The START OFFSET TRIM function (41) toggles to STOP OFFSET

TRIM when selected.

1 2 ... 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Vinten-radamec Quattro SE PDA Manuel d'utilisateur Page 32